Blackcat Usb Jtag Software3/9/2024 This might be better suited for EE but the TDI and TCK circuits have pull-up resistors on them, the TRST circuit has a pull-down resistor, and the TMS and TDO do not have any. The device has a RS232 port but I haven't been able to get anything out of it. I am using a Black Flash USB programmer board and Blackcat software. I found JTAG pads that I soldered pins to but I think JTAG was probably disabled by the processor at boot, at least I can't get anything to connect. I have an Infineon XC161CJ-16F SoC and Micron/ST M29W320EB parallel nor flash memory that I am trying to dump the firmware from but I'm not sure how to proceed.
0 Comments
Leave a Reply.AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |